ClearPix CFB22DN-H2 Guia de Instalação

Installation Guide Clearpix Analog Video Encoder Model:CPX-ENC40-H2920-0046A-Rev1

2Rear ViewFeature DescriptionConnection Status LEDProvides information about device operation. See the section about LED indicators for more informati

3InstallationRequired Tools and Materials• Small slotted screwdriver with 5/64” or 2 mm blade width — for connecting power when not using Power over E

4The encoder can be attached to the bracket by lining up the four holeson the bottom of the encoder with the hole pattern on the bracket andscrewing t

5• Power over Ethernet (PoE) Class 3 — If PoE is available, the encoder is automatically detected when the network cable is connected.• External Power

6• ARP/Ping method. For more information, see Setting the IP Address through the ARP/Ping Method.• Network Video Management software application (for

7Cable ConnectionsConnecting PowerNOTE: Do not perform this procedure if Power over Ethernet (POE) is used.If PoE is not available, the encoder needs

8Connecting to External DevicesExternal devices are connected to the encoder through the I/Oterminal. The pinout for the I/O terminal is shown in the

9Connecting Microphones and SpeakersThe encoder can be connected to up to four external microphones andspeakers through the audio connectors. The audi

10LED IndicatorsOnce the encoder is connected to the network, the connection statusLEDs will display the encoder’s progress in connecting to the Netw

11Reset to Factory Default SettingsIf the encoder no longer functions as expected, you can choose torestore the encoder to its factory default setting

12Setting the IP Address Through the ARP/Ping MethodComplete the following steps to configure the encoder to use aspecific IP address:1. Locate and co

13SpecificationsEncoderVideo Input BNC connectorAudio Input/Output Line-level signal, TRS mini-jack (3.5 mm)NetworkNetwork 100Base-TXCabling Type CAT5

14

15Limited Warranty & Technical SupportClearPix warrants to the original consumer purchaser, that thisproduct will be free of defects in material a

iImportant Safety InformationThis manual provides installation and operation information andprecautions for the use of this encoder. Incorrect install

iimodel series. External power connections must be properly insulated.• Do not connect directly to mains power for any reason.• Do not install near an

iiiRegulator NoticesThis device complies with part 15 of the FCC Rules. Operation issubject to the following two conditions: (1) This device may not c

ivOther NoticesCompilation and Publication NoticeThis manual has been compiled and published covering the latestproduct descriptions and specification

Table of ContentsOverview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1Front View . . . . . . . . . . . . . . . . . . . . . . . . .

1OverviewFront ViewFeature DescriptionVideo Inputs Four BNC inputs for connecting analog video devices.Video Input Status LEDsProvides information abo